Futuristic Table [Big!]
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€22.74 – €27.80 net (excluding VAT)
For file: Futuristic_Table_0.25mm_PETG_MK3S_23h42m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €25.27 excluding VAT (range midpoint).
- Weight reported by the author
- 374 g
- Print time reported by the author
- 23.7 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Futuristic Table or Stand that is very durable for decorative use. This is a big print! Made 100% with TinkerCad.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 38
- Makes
- 0
- Views
- 311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution
Futuristic themed table for decorative use.
I made this with TinkerCAD for a friend. It uses basic geometry shapes and I added a few details to make it look more futuristic. You can cut the legs down a bit in PrusaSlicer if you want to use this as a screen stand. It will hold up as it is pretty tough!
How to print:
Use the provided gcode for your MK3S+ (PETG). If you use the STL instead, take note of the following recommendations:
- Put the table with the deck/top down onto the platter.
- Center as much as possible on the platter.
- 0.25 mm layer height (first layer 0,2 mm)
- Honeycomb infill (12%)
- 4 upper & lower layers
- 3 perimeters
- Perimeters : 45 mm/s
- Small perimeters : 25 mm/s
- External perimeters : 45 mm/s
- Infill : 80 mm/s
- Solid infill : 80 mm/s
- Top solid infill : 40 mm/s
- Bridges : 60 mm/s
- Gap fill : 20 mm/s
- Travel : 180 mm/s
- First layer speed : 15 mm/s
PETG temperature settings (Prusament):
- Nozzle : 240 °C (First layer) / 235 °C (Other layers)
- Bed : 85 °C (First layer) / 90 °C (Other layers)
Warping:
No warping on my prints whatsoever. If yours warps, make sure the bed is really really clean and grease free. If it still warps, cut down the first 2 mm of the table deck/top in PrusaSlicer to make the table deck/top thinner. It helps with warping.