Prusa XL + Buddy3D [+ (optional) EnXlosure] = Finally a proper camera! V2.1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An improvement for the Prusa XL to be ablet to use the Buddy3D Camera - even with the EnXlosure.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 30
- Makes
- 0
- Views
- 384
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model allows you to use the Buddy3D camera with the Prusa XL. It even works with the EnXlosure (but that is tight).
This is a multi-remix of multiple models:
- The 3DBuddy redux model
- The Heatbed accessory mount
The new version 2 has now also a cable management and is so low that it does not collide with the EnXlosure top anymore.
What I have changed:
A. For the redux model I replaced the back with sturdier pins which do not break that easily (I tried printing the back multiple times and every time I pressed the case together at least one of the pins broke - not any more!)
B. For the heatbed accessory mount I added a mount for the redux model and modified the pole into a telescoping pole which can be adjusted to fit close to the heatbed. Note: I used heat inserts to allow for an easy M3 screw tigtening.
C. I added a cable routing shaft.
Needed:
- A Buddy 3D cam (see redux model for how to rebuild)
- 2 M3 inserts and a soldering iron
- 2 8mm M3 screws
Note: As the bed is moving, you should make sure that the cable is not hooking up somewhere where it shouldn't. I think that it might be possible to use the cable carriage from the bed for this too (will try to see if I can make this to work).
New: Version 2.1
If you want to use the micros SD card, you can use the CameraPoleV2.1 which can be extended further outside. However - note that if you use that, you cannot close the door aymore once the camera is extended to the back.
I hope this helps!