1 / 4
Prusa XL + Buddy3D [+ (optional) EnXlosure] = Finally a proper camera! V2.1 — zdjęcie 1
1 / 4

Prusa XL + Buddy3D [+ (optional) EnXlosure] = Finally a proper camera! V2.1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An improvement for the Prusa XL to be ablet to use the Buddy3D Camera - even with the EnXlosure.

Ocena
0 / 5
Polubienia
10
Pobrania
30
Wydruki
0
Wyświetlenia
383
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model allows you to use the Buddy3D camera with the Prusa XL. It even works with the EnXlosure (but that is tight). 

This is a multi-remix of multiple models:

  1. The 3DBuddy redux model
  2. The Heatbed accessory mount

The new version 2 has now also a cable management and is so low that it does not collide with the EnXlosure top anymore.

What I have changed:

A. For the redux model I replaced the back with sturdier pins which do not break that easily (I tried printing the back multiple times and every time I pressed the case together at least one of the pins broke - not any more!)

B. For the heatbed accessory mount I added a mount for the redux model and modified the pole into a telescoping pole which can be adjusted to fit close to the heatbed. Note: I used heat inserts to allow for an easy M3 screw tigtening.

C. I added a cable routing shaft.

Needed:

  • A Buddy 3D cam (see redux model for how to rebuild)
  • 2 M3 inserts and a soldering iron
  • 2 8mm M3 screws

Note: As the bed is moving, you should make sure that the cable is not hooking up somewhere where it shouldn't. I think that it might be possible to use the cable carriage from the bed for this too (will try to see if I can make this to work).

New: Version 2.1

If you want to use the micros SD card, you can use the CameraPoleV2.1 which can be extended further outside. However - note that if you use that, you cannot close the door aymore once the camera is extended to the back.

I hope this helps!

 

Tagi