1 / 3
Analog Pot Throttle Control
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed a way to make a pot fully turn without having the handle have to spin all 270 degrees with it.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 22
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
This is a way to make an analog pot spin all 270 degrees while only having the control arm move about 90-100 degrees. The gearing is almost 1:3. I'm using it as a throttle control for an RC Arduino build.
You will need
2 M3x8 Screws
1 M3x14 Bolt
1 M3 washer to place between the large gear and the housing.
I used PETG but I'm sure it would be fine with PLA, ABS, or any other filament. 20% infill.