1 / 2
Voron Bowden Retainer with Fittings and Panel Clip
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I redesigned the Bowden Retainer to use two bowden fittings and added a panel clip tab. Kill two birds with one print.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 180
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I was done with the reverse bowden falling off the retainer so I added ECAS04 bowden fittings (remove the rubber piece on the back as usual). I also added a panel clip tab to the front of it so it can replace two parts into one.
Note: the two tubes are touching edge to edge inside the mount, make sure they are properly cut to ensure smooth passage of the filament.
BOM:
- 2x ECAS04 bowden fittings
- 1x 30mm SHCS
- 1x T-nut (can be recycled from your original panel clip or bowden retainer)
- 2x bowden tube