1 / 2
Voron Bowden Retainer with Fittings and Panel Clip — zdjęcie 1
1 / 2

Voron Bowden Retainer with Fittings and Panel Clip

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I redesigned the Bowden Retainer to use two bowden fittings and added a panel clip tab. Kill two birds with one print.

Ocena
5 / 5
Polubienia
3
Pobrania
21
Wydruki
0
Wyświetlenia
180
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I was done with the reverse bowden falling off the retainer so I added ECAS04 bowden fittings (remove the rubber piece on the back as usual). I also added a panel clip tab to the front of it so it can replace two parts into one.

Note: the two tubes are touching edge to edge inside the mount, make sure they are properly cut to ensure smooth passage of the filament. 

BOM:

  • 2x ECAS04 bowden fittings
  • 1x 30mm SHCS
  • 1x T-nut (can be recycled from your original panel clip or bowden retainer)
  • 2x bowden tube

Tagi