1 / 2
Gardena to 8mm pneumatic dripping tube
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gardena pipe connector to 8mm pneumatic tube (5.5mm inner diameter)
- Rating
- 5 / 5
- Likes
- 33
- Downloads
- 92
- Makes
- 0
- Views
- 490
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
didn’t find a cheap adapter so I made one. To use with 8mm pneumatic like this:
just use hot water to heat up the tube for like 10 seconds and push over smaller end. it should be watertight once cooled down. If not use a small pipe clamp.
use the O-ring of another Gardena adapter or get one of these cheap O-ring set and use the 16 x 2.4 mm one.
https://amzn.eu/d/h7O8nNf
Edit 30.05.2025
made the inner walls thicker to increase stiffness and water tightness
Infill:
100%
support:
no
material:
PLA/PETG (better)
Orientation:
print vertically