1 / 4
Ikea Besta Wall Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Low profile mount for Ikea Besta shelf without back wall
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 20
- Makes
- 0
- Views
- 230
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial
This mount is exclusively for any Ikea Besta shelf without the back wall installed.
- Print in the following orientations
- PETG
- 15% gyroid infill
- 4 perimeters
- 0.15mm layer height
- Requires 2 per Besta shelf
- For better results add some support inside the screw area
Installation:
- Loosely screw the mount to a wall (for the 60cm Besta the holes should be 54cm apart)
- Hang Besta shelf and slide the mounts all the way to its outer walls
- Check if the fit towards the wall is without any wobble when pushed, otherwise add a little bit of tape to the top of the hook of the mount. The Besta shelves (and my walls) required about half a millimeter of tolerance.
- Tighten the screws
- Add screw cover and tighten with a coin or something similar (a screw driver will likely damage them if too tight)
- Lastly push the locking peg through the side of the mount into the Besta to avoid accidental lifting off the mount