1 / 2
18ml paint bottle rack for multiboard
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Did not find a rack that fit these bottles that took up vertical space in place of horizontal space, so made my own.
Should print fine in the standard orientation, i would just use a brim or raft to make sure it sticks unless you are completely certain in your bed adhesion.
Only takes up two horizontal rows of multiboard holes, and just over 9 vertical ones.
The rear pegs should work perfectly well and hold up full load if your printer prints dimensionally correct and fits the small thread.