Watertight Tree Trunk Seed Vase
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tiny vase for storing your plant seeds or tiny amount of water. Stand slightly above 20mm with diameter of around 19mm
- Rating
- 3 / 5
- Likes
- 7
- Downloads
- 46
- Makes
- 1
- Views
- 364
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
This 20.33mm height print completes in 30minutes with 0.05mm layer height and uses up only 1g of filament because of the magic of vase mode. I wanted to produce a watertight vase with natural looking tree trunk features and found this nice 3D scan on Sketchfab by matousekfoto:
https://sketchfab.com/3d-models/wood-chopping-trunk-base-log-ba19a59fdd7f4f01ac5e3f8700b90775
I had to cut some top layers and bottom layers after placing the model on the plate so that the top stays open and the bottom was wide enough. I suppose it also improved my chances of success when I scaled the model down to 25%.
Here's the proof that it holds water:
