Downpipe Brace (dlaha na okapový svod)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Downspout Brace to provide stability around your Rainwater Diverter
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Provide stability to your rainwater catchment installation. This is a simple brace to prevent a tube from bending out of shape if you had to cut it and insert a diverter, resulting in multiple short joints.
The brace consists of two 15-mm metal reinforcement tubes to run along on both sides of the downpipe, affixed with 3D-printed clamps. The length of the tubes is optional, as is the number of clamps. However fewer than three will work poorly.
There are two types of clamp: passthrough and end piece, the only difference being that the cutouts for the 15-mm reinforcing tubes are stubbed in the end piece. The clamp prints in halves, which are axially symmetrical, that is, you need two of the same opposing each other to form a single clamp.
The clamps print nicely without supports. Screw them together with 6-mm metric screws, at least 40 mm long. The opposing hole takes a 6-mm metric nut. I prefer nylock nuts.
This particular model is designed for 10-cm (4") diameter downpipes. Comment if you know of another common diameter to cover.