Downpipe Brace (dlaha na okapový svod)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Downspout Brace to provide stability around your Rainwater Diverter
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Provide stability to your rainwater catchment installation. This is a simple brace to prevent a tube from bending out of shape if you had to cut it and insert a diverter, resulting in multiple short joints.
The brace consists of two 15-mm metal reinforcement tubes to run along on both sides of the downpipe, affixed with 3D-printed clamps. The length of the tubes is optional, as is the number of clamps. However fewer than three will work poorly.
There are two types of clamp: passthrough and end piece, the only difference being that the cutouts for the 15-mm reinforcing tubes are stubbed in the end piece. The clamp prints in halves, which are axially symmetrical, that is, you need two of the same opposing each other to form a single clamp.
The clamps print nicely without supports. Screw them together with 6-mm metric screws, at least 40 mm long. The opposing hole takes a 6-mm metric nut. I prefer nylock nuts.
This particular model is designed for 10-cm (4") diameter downpipes. Comment if you know of another common diameter to cover.