Expo Marker Eraser Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My wife wanted a simple way to keep an eraser with her student's Expo markers
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 38
- Makes
- 0
- Views
- 176
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other 3D Objects for Learning
- License
- Standard Digital File License
An easy way to attach an eraser to your dry erase markers while maintaining the ability to place the cap on the end of the marker while using.
Fit is snug, but not too tight on my prusa XL when printed at .15mm LH. I used PLA, and it seals nicely and feels very similar to the original cap.
Print square side down with supports on bed only for best results.
Estimated cost is $.017 per piece, so a classroom set of 40 is around $7 for the printed part. Print time for me is 22 hours for 40 pieces.
Felt pads for the thin version can be found here for about $8:
For the thicker version, as shown, I recommend getting these thicker pads and splitting them to about 3/8" thick.