1 / 3
Tenkara Rod Cap - Size it to Your Rod — image 1
1 / 3

Tenkara Rod Cap - Size it to Your Rod

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A drop-in replacement Tenkara rod cap. Default size is for the Nissin Zerosum Oni 395.

Rating
0 / 5
Likes
4
Downloads
43
Makes
1
Views
158
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike
Introduction

I developed this model to make it easy and affordable to replace your Tenkara rod caps. The cap is tolerant of size and material differences, but you'll likely need to scale it a little to fit your particular rod.

Size It To Your Rod 

The model is sized for my rod, the Nissin Zerosum Oni 395. If you want to fit a different rod, then you'll need to scale it up or down. Scaling can easily be done in the slicer.

If you don't know the diameter of your Tenkara rod's hole, then you can try to find the scale factor using a guess-and-check approach. However, if you know the diameter of your Tenkara rod's hole in inches, D, then you can find the scale factor, S, by solving this equation:

S = ( D + 0.02 ) / 0.406

Note: To get the scale as a percentage, multiply the scale factor (S) by 100.

Printing

The cap must be printed in a flexible material like TPU. I recommend using a TPU that's 90a or harder. You can make the plug stiffer by increasing the number of shell walls, and also by increasing the infill percentage.

Prints without supports.

Use

Insert into the end of your rod. There should be enough resistance that the plug won't fall out on its own, but it should also go in easily enough as to not damage the rod.

Remixing

Once you get the fit right, please share the details of your success on printables. Be sure to post your rod type, the scaled STL, your material, and the print setting. If you upload it as a ‘remix’ (a modification of an existing file), it will be linked to this page for others to find.

Acknowledgments 

Thanks to @JackK_1129193 for helping me develop this model. Their early input and suggestions got this project published.

Tags