Gasket for a utility transfer pump
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement gasket designed for DEKO DKGP250R01-US Utility Transfer Pump PAS-30
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 61
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
This is a replacement gasket for DEKO PAS-30 sold on amazon, but is also likely compatible with the similar impeller-style water pumps of the same design.
Here's the product page – https://www.amazon.ca/Water-Transfer-Pump-DEKOPRO-Electric/dp/B0CB64B8CF
The original paper gasket was made of wax paper, it's 0.4mm thick and there were some issues of impeller rubbing on top plate which would overload and stall the motor. I traced the issue to the original gasket not being thick enough; my bodge solution was to not tighten pump plate entirely so the motor could start, but that led to the original gasket blowing out.
I set this gasket width to be 0.8mm. I tried pressurizing backyard irrigation system and this pump works without motor stalling or pump leaking.
Additional measurements are in the pump_gasket_public.scad source file.
Print settings:
Material: TPU 91A
Infill: 100%
Layer height: 0.1mm
See pump_gasket_v1.3mf for detailed print settings.