1 / 8
YASH 2022, yet another filament spool holder — image 1
1 / 8

YASH 2022, yet another filament spool holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Filament spool holder that fits in nicely with the Prusament spools... hexagon style.

Rating
0 / 5
Likes
14
Downloads
60
Makes
0
Views
691
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Yet another filament spool holder. Simple, easy to use and - if I may say so - good looking.

This is a semi-low profile spool holder with open design using a hexagon pattern. The spool holder has no settings or adjustments of any kind. Just put your spool on top and print!

It can take spools up to 87mm in width and minimum diameter of around 160mm. Research shows about 96.4% of the spools on the market will fit nicely. If your spool is wider no sweat, we've got you covered. Just connect two holders together using the supplied connection plugs.

Update 2022-02-13: two alternatives have been added:

  • screw version: This version can be used with a short screw instead of a set of nuts and bolts. The holes for the screw are 3.5mm.
  • glue version: This bar has a tighter fit (4mm vs 3.9mm) so you may need to sand it down a bit. After you succeeded getting it in position you can drop a bit of superglue in the slit to fix it in place (don't forget the rollers!).
    The 'glue’ side version has no screw/bolt hole. The bar can be pushed into the lower hexagon (look for slightly chamfered pocket) for an even cleaner look.

Parts needed:

  • 4x 608 bearing
  • 4x M3 hex nut
  • 4x M3 1mm bolt with countersunk head (DIN 7991 / ISO 10642) or 4mm screw (see alternative bar)

Parts to print:

  • 2x sides
  • 2x bars (normal or screw version)
  • 2x rollers

The connection plugs are optional. You can use these to connect two of more spool holders together.

Printing tips:

  • designed for 0.40mm nozzle and 0.20mm layer height
  • parts don't need support
  • roller: print standing upwards using random seem position (has been successfully printed using draft or 0.30mm layer height to reduce print time)
  • bar: print with hex socket up
  • connection plugs: make sure slot is vertical

Assembly:

  • Insert the 608 bearings in the rollers on either side
  • Insert the the hex nuts in the bars, best done by pressing the bar on top of a hex nut
  • Pull the hex nuts deeper into the bar socket by tightening a bolt, the hex nuts should be within the hex outline of the bar
  • Put the bars, nut facing upwards into one side
  • Lock the bars in place by screwing in the bolts from the bottom
  • Press the rollers onto the side with the bars connected
  • Pick up the second side, align bar sockets and rollers, press gently to push everything together
  • Screw the last two bolts into the second side

As alternative for using the nut and bolt you can use the screw version of the bar and use a 4mm short screw to hold everything together.

Next: Post a make (optional) and enjoy your YAFSH 2022 spool holder. Happy printing!

** Filaments clips starring in the photos: https://www.prusaprinters.org/prints/3458-filament-clip-v8 best used in combination with the excellent press-in-assists: https://www.prusaprinters.org/prints/60008-filament-clip-v8-press-in-assist (disclaimer: I am affiliated)

Tags