Fursuit Body Dryer 120 v1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fursuit body dryer based around a 120mm case fan, that can be disassembled for travel.
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 71
- Makes
- 1
- Views
- 449
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Costume Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introducing the Fursuit Body Dryer 120 v1.
(I am very much a Fusion 360 noob, so any feedback appreciated!)
Frustrated by the cost of what is basically a fan and a hanger from other sources, I designed my own around a standard 120mm case fan.
To save space and weight the hanger does not actually have its own hook. Instead there are holes through which you can thread paracord as shown, then hang it on anything convenient like a hotel closet hanger or an over-the-door hook (folding, 3D-printable one coming soon!). You can use the single length of paracord threaded as shown, or create a loop on either side.
For the fan, you need a high CFM fan, I'm using the Wathai 12038 from Amazon. You'll also need a way to power the fan, you can also get a power supply + speed controller from Amazon as well. Keep in mind the Wathai requires a 2 amp power supply if you want to run it at full speed! Some only supply at most 1.5 amps.
Although there are holes on the bottom to screw in the fan, you don't have to use them - you can just rest it in the tray. This is convenient if you want to use the same fan for a head dryer that also uses a 120mm fan (e.g. https://www.printables.com/model/1280850-fursuit-head-dryer), since you'd only need to pack one fan, although you can't dry both at once (obviously).
Some features of this model:
- As mentioned, can be disassembled for ease of transport. Packs down small!
- No supports required for printing, at least on my Bambu.
- Strong arm/box attach points, for supporting even chonky, soaking wet fursuits.
- Vent holes on arms (not that shoulders get that wet anyway…)
Printing tips:
None really! I use 15% infill, if you want to make it stronger adjust as needed. Prints fine in both PETG and PLA.
One thing to note: while you may be tempted to screw the fan into the dryer, then support it via paracord or other material attached to the fan, I wouldn't recommend it. Fans aren't intended to be load bearing, and the bottom of the fan box is not designed to support the weight like that. I may do a version in the future that uses attach points that come up through the fan holes, but the current design seems to work well enough.