1 / 5

Filamentone Two

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

fi·luh·mehn·tone - A vintage inspired portable speaker.

Updated at source: Jun 1, 2025

Model information

the Filamentone Two… two channels for twice the enjoyment.

Note: The design requires a 256x256 mm minimum printable area for it to print in one piece.

The pictured model is printed in Polymaker PolyTerra PLA muted blue for the body and muted white for the front, rear and legs.

Layer height 0.15

Wall count 3-4

Top and bottom layers 4

Infill 20-25%

Minimal overhangs but supports are required on the body.

The logo needs a pause and filament change around layer 38 (layer height 0.15)

This build makes use of the following components:

2x Dayton Audio ND65-8 2-1/2" Full-range drivers

Dayton Audio KAB-215v2 Amplifier Board

Dayton Audio KAB-BE 3 x 18650 Lithium Battery extension Board

3x Molicel P30B 18650 cells (Protection: none)

Mini On/On Toggle Switch SPDT Miniature

19v 4.74A 90W laptop charger

M3 threaded Heat Set Inserts

4x M3 standoffs for stacking the battery and amplifier boards

M3 Hex Socket Head Cap bolts

5x2mm Self-Adhesive Clear Rubber round bumpers

5.5 x 2.5 MM 10A DC Power Jack Socket

3M VHB Double sided tape for attaching the battery/amp board holders and the front plate if required.

Optional back plates - closed, open and experimental PR.

Optional - Passive Radiator Rubber Diaphragm 120 x 59 mm

The components were selected to allow mostly plug and play to keep soldering to a minimum.