Filamentone Two
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
fi·luh·mehn·tone - A vintage inspired portable speaker.
- Ocena
- 5 / 5
- Polubienia
- 225
- Pobrania
- 387
- Wydruki
- 2
- Wyświetlenia
- 3744
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
the Filamentone Two… two channels for twice the enjoyment.
Note: The design requires a 256x256 mm minimum printable area for it to print in one piece.
The pictured model is printed in Polymaker PolyTerra PLA muted blue for the body and muted white for the front, rear and legs.
Layer height 0.15
Wall count 3-4
Top and bottom layers 4
Infill 20-25%
Minimal overhangs but supports are required on the body.
The logo needs a pause and filament change around layer 38 (layer height 0.15)
This build makes use of the following components:
2x Dayton Audio ND65-8 2-1/2" Full-range drivers
Dayton Audio KAB-215v2 Amplifier Board
Dayton Audio KAB-BE 3 x 18650 Lithium Battery extension Board
3x Molicel P30B 18650 cells (Protection: none)
Mini On/On Toggle Switch SPDT Miniature
19v 4.74A 90W laptop charger
M3 threaded Heat Set Inserts
4x M3 standoffs for stacking the battery and amplifier boards
M3 Hex Socket Head Cap bolts
5x2mm Self-Adhesive Clear Rubber round bumpers
5.5 x 2.5 MM 10A DC Power Jack Socket
3M VHB Double sided tape for attaching the battery/amp board holders and the front plate if required.
Optional back plates - closed, open and experimental PR.
Optional - Passive Radiator Rubber Diaphragm 120 x 59 mm
The components were selected to allow mostly plug and play to keep soldering to a minimum.