1 / 4
Superflux Motor Bearing Seals
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bearing seals for your superflux onewheel motor!
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 47
- Makes
- 0
- Views
- 232
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
These bearing seals were designed with a lip on the bottom of them to lock them into place. These seals should barely sit below the face of the motor. If they aren't, it is very likely they are not locked into place. Fill up the cavity with grease and grease the inside surface (axle surface, not the one with the lip) to ensure adequate protection and no squeaking! Print in 100% TPU!
These seals have been tested on multiple MKII superfluxes, please give feedback on other variants so I can improve them if needed!