1 / 1
Jaw Pin and Magnet Punch for Denture Bit Holder — image 1

Jaw Pin and Magnet Punch for Denture Bit Holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.08 – €0.09 net (excluding VAT)

For file: Denture_Jaw_Pin_0.2mm_PLA_MK3S_5m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.09 excluding VAT (range midpoint).

Weight reported by the author
1 g
Print time reported by the author
5.4 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

A snap in place pin for the jaw hinge and a punch to set magnets in place. See below for the bit holder model.

Rating
5 / 5
Likes
43
Downloads
202
Makes
4
Views
1,812
Reviews
4

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

I found the spec sized magnets were a tight fit, so I made a punch to smack them in place with a hammer.   Also a pin for the jaw for those who don't have the right sized fasteners on hand.

Cheers!