1 / 3
3" PVC Rain Barrel Diverter with 1.25" outlet — image 1
1 / 3

3" PVC Rain Barrel Diverter with 1.25" outlet

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is an automatic overflow Rain Barrel Diverter for 3" PVC Pipe with a 1.25" side take-off that fits 1.25" sewer…

Rating
0 / 5
Likes
17
Downloads
112
Makes
0
Views
954
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This is an automatic overflow Rain Barrel Diverter for 3" PVC Pipe with a 1.25" side take-off that fits 1.25" sewer pump drain hose. My rain barrel had an opening that fits 1.25" hose and I couldn't find a design that used 3" PVC.

Water flows to the lower cone and overflows to the side take-off which is positioned just above the height of the rain barrel. When the rain barrel fills-up water will back-up into the rain diverter and flow over the upper cone and down the middle of the diverter.

Untested in a real rainfall . . . just in the sink! I will update when I get the first rain-fall :-)

Only needs support for the bottom cone inner ledge and the side-tube. Depending on your printer overhang ability, you may need supports inside the tube as well. the upper cone does-not need supports.

It's a long print - I used .3mm layer height and it's about 9-hours.

It is a good fit on 3" PVC pipe. Could be water proofed with glue - but I don't think it needs to be waterproof.

Buy me a Beer! 

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

.3

Infill: 

20

Filament: Overture PETG Green

 

 

 

Category: Outdoor & Garden

Tags