1 / 3
3" PVC Rain Barrel Diverter with 1.25" outlet — zdjęcie 1
1 / 3

3" PVC Rain Barrel Diverter with 1.25" outlet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an automatic overflow Rain Barrel Diverter for 3" PVC Pipe with a 1.25" side take-off that fits 1.25" sewer…

Ocena
0 / 5
Polubienia
17
Pobrania
112
Wydruki
0
Wyświetlenia
954
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is an automatic overflow Rain Barrel Diverter for 3" PVC Pipe with a 1.25" side take-off that fits 1.25" sewer pump drain hose. My rain barrel had an opening that fits 1.25" hose and I couldn't find a design that used 3" PVC.

Water flows to the lower cone and overflows to the side take-off which is positioned just above the height of the rain barrel. When the rain barrel fills-up water will back-up into the rain diverter and flow over the upper cone and down the middle of the diverter.

Untested in a real rainfall . . . just in the sink! I will update when I get the first rain-fall :-)

Only needs support for the bottom cone inner ledge and the side-tube. Depending on your printer overhang ability, you may need supports inside the tube as well. the upper cone does-not need supports.

It's a long print - I used .3mm layer height and it's about 9-hours.

It is a good fit on 3" PVC pipe. Could be water proofed with glue - but I don't think it needs to be waterproof.

Buy me a Beer! 

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

.3

Infill: 

20

Filament: Overture PETG Green

 

 

 

Category: Outdoor & Garden

Tagi