Miniature Vacuum Ejector (Air Powered Vacuum Pump)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this little vacuum generator, also known as an ejector, for use with a vacuum cup for robotic manipulation.…
- Rating
- 0 / 5
- Likes
- 44
- Downloads
- 351
- Makes
- 2
- Views
- 2,565
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Share Alike
I designed this little vacuum generator, also known as an ejector, for use with a vacuum cup for robotic manipulation. Blowing air in one side at 50 PSI will generate about 5 PSI of vacuum at the side port. The advantage of using a lightweight eductor right at the end-effector (as opposed to using a remotely located vacuum pump) is that you can control the vacuum action nearly instantaneously for faster pickup and eject times.
It is only 1.225" long and weighs less than 5 grams. It's designed for use with 10-32 pneumatic fittings. (I've included the Solidworks part file for anyone wanting to optimize it or add mounting features.)
Printing
Use a 0.35mm line width and a 0.2mm layer thickness. I used PLA, but ABS or PETG should work as well.
Post Printing
After printing you will need to clean out the internal nozzle orifice with a 0.047" dia. drill bit. You will also need to tap the input and side vacuum ports with a 10-32 tap.
Category: Engineering