1 / 7
IKEA Vallhorn Swivel Holder and Rain Cover — image 1
1 / 7

IKEA Vallhorn Swivel Holder and Rain Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ball joint swivel mount for IKEA Vallhorn motion sensor

Rating
0 / 5
Likes
9
Downloads
64
Makes
0
Views
343
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A practical ball joint swivel mount with a rain cover for the IKEA Vallhorn motion sensor.

Upgraded wall mount V2 added!

This mount allows you to easily adjust the angle of your Vallhorn sensor and provides some protection from rain if used outdoors.

The back cover of the Vallhorn can be screwed to the inside of the holder, allowing you to remove the sensor as usual for battery changes or to access the buttons.

The wall mount prints with the ball joint tightener connected to the rest of the mount, which can be separated using a small saw after printing. Alternatively, you can print the version with a pre-cut slit, but please note that supports and overhangs may be more challenging to print cleanly.

Hardware


For wall mount to tighten ball joint

For Vallhorn holder: Some appropriate countersunk screw

Print Settings:


Material: 

PLA

Infill:

100% Concentric

Vertical Shells:

3 perimeters

Supports:

Yes, (support on build plate only). Printed with ball joint facing print bed.

 

Tags