1 / 7
IKEA Vallhorn Swivel Holder and Rain Cover — zdjęcie 1
1 / 7

IKEA Vallhorn Swivel Holder and Rain Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ball joint swivel mount for IKEA Vallhorn motion sensor

Ocena
0 / 5
Polubienia
9
Pobrania
64
Wydruki
0
Wyświetlenia
341
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A practical ball joint swivel mount with a rain cover for the IKEA Vallhorn motion sensor.

Upgraded wall mount V2 added!

This mount allows you to easily adjust the angle of your Vallhorn sensor and provides some protection from rain if used outdoors.

The back cover of the Vallhorn can be screwed to the inside of the holder, allowing you to remove the sensor as usual for battery changes or to access the buttons.

The wall mount prints with the ball joint tightener connected to the rest of the mount, which can be separated using a small saw after printing. Alternatively, you can print the version with a pre-cut slit, but please note that supports and overhangs may be more challenging to print cleanly.

Hardware


For wall mount to tighten ball joint

For Vallhorn holder: Some appropriate countersunk screw

Print Settings:


Material: 

PLA

Infill:

100% Concentric

Vertical Shells:

3 perimeters

Supports:

Yes, (support on build plate only). Printed with ball joint facing print bed.

 

Tagi