Creality Space Pi Drying Stand!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drying stand for the Creality Space Pi filament dryer! There are short and long leg options.
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 168
- Makes
- 2
- Views
- 1,461
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I got the Creality Space Pi to dry filament because I heard good things about it. However, I noticed that while filament is drying, the base of the dryer gets pretty hot, and I wanted a way to raise it for cooling and to prevent any potential heat damage. So, I created this stand, and it fits it perfectly! The stand in the picture is printed fully in PLA (mix of Polymaker and Bambu), and it has been tested with 12 hours of drying at 50 degrees C and observed no deformation on the stand (the base doesn't get as hot as the inside, but I wanted to be sure).
DISCLAIMER
This stand made of PLA hasn't been tested at the highest drying setting of 65-70 degrees C, so take caution if you decide to print using PLA and dry filaments at a higher temp. I don't think anything bad will happen since the base doesn't get as hot and has vent holes to cool. If you have multiple colors of PETG or ABS, those materials would be the safer option, but the colors I have for those materials are limited so I just went with PLA.
The attached files include:
- Short Legs - Height of the top of the stand is 120 mm off the ground (2x needed, and they are press fit so some sanding may be required based on filament type and printer used)
- Long Legs - Height of the top of the stand is 230 mm off the ground (2x needed, and they are press fit so some sanding may be required based on filament type and printer used)
- The drying base with the logo prepped for multicolor printing (sitting flush to the side it is on)
- The drying base with the logo engraved (embossed) if single-color printing is desired
- The full model with the legs attached in case you want to print the full stand in one go
- A .3MF of the model with colors added (made for the Bambu Lab X1-Carbon, but can be used for any Bambu machine except the A1-Mini)
- A .3MF of the model with no colors added (made for the Bambu Lab X1-Carbon, but can be used for any Bambu machine except the A1-Mini)
The .3MF files are for the short legs only (the long leg option was added later). Let me know if anything additional should be added. I plan on making stands for other types of dryers, although I only own the Creality Space PI. Hope everyone enjoys!
MakerWorld Page: Creality Space Pi Drying Stand! by ExllntButtz MakerWorld: Download Free 3D Models