Zorbiter_Extruder Filament Sensor Mount for MMU use
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
to use the Zorbiter_Extruder with the MMU Filament-Sensor is triggert by Extruder-Gear
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 34
- Makes
- 0
- Views
- 499
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
Zorbiter_Extruder Filament Sensor Mount for MMU use
is for the ZOrbiter V1.5 Geared Extruder by ZARIBO
these Sensor Mount is needet to trigger when Filament is loadet to the Extruder-Gear
and based on
ZOrbiter V1.5 Geared Extruder by ZARIBO
https://www.prusaprinters.org/prints/68982-zorbiter-v15-geared-extruder-by-zaribo
parts need :
1pcs PC4-M10
Prusa-IR-Filament-Sensor (reused from Zorbiter-Extruder)
M2 screw (reused from Zorbiter-Extruder)
M3x10 (reused from Zorbiter-Extruder)
Disasemble the IR-Sensor , Bal and Lever inside the Zorbiter-Extruder
If you use the PC4-M10 , you need to change the Ball-Block with the PTFE-thru-Block
Mount the Prusa-IR-Filament-Sensor with the M2 Screw bettwen both Covers
the Sensor kabel need´s a little bit longer , so you need to pull it from the Einsyboard thrue the Kabel-Loom to the Extruder.
Pay attation when connect the Plug the red kabel show to the Filament-hole (PC4) , the Black to the outside .
the Trigger-Arm needs bettwen the sping and the Orbiter-Lever.
Recommended material: PETG or ABS/ASA.
switch "support on Buildplate” on..
Print orientation :
as it is