Ultimate Cereal Container Filament Drybox - Respin_061425

This is a respin of GunplaMark’s very nice drybox design. I wanted to be able to stack the boxes with better stability though, so I patched the top corner brackets into a single piece, and adjusted geometry to provide a perfect fit when stacking.  It also changes the hygrometer to a large analog one that you can find on AliExpress. I like these analog hygrometers because it has a slotted screw on the back side that allows me to do a single-point calibration at near 0% humidity. To calibrate I just place the hygrometer in a large bag of fresh dessicant for a day, then turn the screw to calibrate to 0%. Of course the sensor’s gain and linearity is probably not that good, but not near as bad as the garbage information those digital sensor provide at low humidity levels.  

Hardware needed:                                                                     

• (4)  608 Bearingswith Nylon Caged (https://www.amazon.com/dp/B0D3LXRX5X
• (8)  uxcell M8 304 SS Flat Washers, 8x14x0.5mm https://www.amazon.com/dp/B0C3TYGH7D
• (4)  4-40 panhead screws, 5/16” length https://www.amazon.com/dp/B00F34SA0A
• (4)  4-40x1/8”x4.6mm threaded insert https://www.amazon.com/dp/B0DPJBYFMT
• Wood screw with about 0.135” diameter, about 3/8” long
• Washer for pneumatic fitting: Approx ID:10mm OD:20-22mm
• Pneumatic Coupler https://www.amazon.com/dp/B01IB81IHG
• Wildone Cereal Storage Container 4L  https://www.amazon.com/dp/B07NP98YKY
• Hygrometer (Link)