Minimalist heat insert press - 19mm wired soldering iron side mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For mounting a Ø19mm wire soldering iron
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 37
- Makes
- 0
- Views
- 309
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Replaces the ts100_arm_mount part to allow the installation of a wire soldering iron of any length.
The support is printed in one with no assembly required.
Note that to make this support, I was largely inspired by the hinge created by @JimBrookhyser_558983
https://www.printables.com/model/1224036-simple-box-with-print-in-place-zero-clearance-vert
Its design allows the hinge to be printed directly in place vertically, great job Jim! 👍
Once the support has been printed, the hinge has to be forced a little to close it again. Once you've done that, you'll see that the hinge is solid and smooth to use.
For printing, you will (unfortunately) have to place some supports manually