Samsung Refrigerator Crisper Drawer Reinforcement Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This part reinforces the front panel of the vegetable/fruit drawer in Samsung refrigerators, which is prone to cracking.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 97
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Samsung Refrigerator Crisper Drawer Reinforcement Bracket
This custom-designed part reinforces the front panel of the vegetable/fruit drawer in Samsung refrigerators, which is prone to cracking over time, especially at the top center where users typically push or pull to open the drawer. In my case, the drawer began cracking after just two years of use.
The part helps prevent further damage by redistributing stress away from this weak point, minimizing flex during regular use. It's designed for a tight, secure fit and may require some force to install. Stretch it slightly and tap it into place with a mallet if necessary.
I’m currently using this part on one drawer to stop an existing crack from spreading, and on another drawer proactively to prevent any cracking from starting.
Printed in PLA with added infill and reinforced geometry in the upper section for extra durability where it’s most needed.
When I printed it I printed it with the main body using the following:
- 0.2mm layer height
- 20% infill
- 3 wall loops
For extra strength, I added a modifier layer (from 40mm to top) with the following changes: (It might be overkill, but I wanted to help ensure it would hold up.
- 0.18mm layer height
- 100% infill (rectilinear)
- 4 wall loops