Magnetic Fan Connector
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.49 – €0.60 net (excluding VAT)
For file: Fan_connect_V1_D5_Mag5x3_0,4-0,7_120x25___0.2mm_PLA_MK3S_38m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.54 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 37.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Magnetic connectors for 120mm PC fans This design will always connect. You can turn and twist but still attach each fan.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 17
- Makes
- 0
- Views
- 574
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Connectors for 120x25mm Fans.
I choose magnetic design because I wanted it to work in any direction and arrangement.
You can attach each fan in any direction or on any side.
Magnets have to be inserted while printing!
Make sure to attach magnets correct.
Magnets should point in directions according to sketch!
North/South marking is only to help for orientation. Magnets closest to Noth should point outwards with North side.
You can check your North/South side with a compass.
Note:
V1 with Ø5x3 Magnets. You need 4 Magnets each Edge.
I used different wall thickness between magnets and outside walls, cause I could not workout clean slicing of vertical walls. Bottom layer is 0.4 ; vertical layer is 0.7mm. Thick vertical wall reduces performance of magnets, maybe you can help me with the slicing to fix this. The seam should not be at the magnets, then vertival call can be reduced to one wall…
Make sure to have the right orientation while printing. Or else, let me know how to make a clean slicing with no seams in areas of the magnets.
Ø5x3 Magnets might be too weak for other than stacking of fans.
Will add models for bigger magnets soon.
Will also add models for magnetic feet soon.
One Model with Ø5mm hole, other with Ø4mm hole.
Any suggestions or help for slicing, let me know…