1 / 9
Magnetic Fan Connector — zdjęcie 1
1 / 9

Magnetic Fan Connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

0,49 € – 0,60 € netto (bez VAT)

Dla pliku: Fan_connect_V1_D5_Mag5x3_0,4-0,7_120x25___0.2mm_PLA_MK3S_38m.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,54 € netto (środek widełek).

Masa podana przez autora
5 g
Czas druku podany przez autora
37,8 min
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Magnetic connectors for 120mm PC fans This design will always connect. You can turn and twist but still attach each fan.

Ocena
0 / 5
Polubienia
20
Pobrania
17
Wydruki
0
Wyświetlenia
574
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

Connectors for 120x25mm Fans.

I choose magnetic design because I wanted it to work in any direction and arrangement.

You can attach each fan in any direction or on any side.

 

Magnets have to be inserted while printing!

 

Make sure to attach magnets correct.

Magnets should point in directions according to sketch!

North/South marking is only to help for orientation. Magnets closest to Noth should point outwards with North side.

You can check your North/South side with a compass.

 

Note:
V1 with Ø5x3 Magnets. You need 4 Magnets each Edge.
I used different wall thickness between magnets and outside walls, cause I could not workout clean slicing of vertical walls. Bottom layer is 0.4 ; vertical layer is 0.7mm. Thick vertical wall reduces performance of magnets, maybe you can help me with the slicing to fix this. The seam should not be at the magnets, then vertival call can be reduced to one wall…

Make sure to have the right orientation while printing. Or else, let me know how to make a clean slicing with no seams in areas of the magnets.


Ø5x3 Magnets might be too weak for other than stacking of fans.
Will add models for bigger magnets soon.
Will also add models for magnetic feet soon.

 

One Model with Ø5mm hole, other with Ø4mm hole.

 

Any suggestions or help for slicing, let me know…

 

Tagi