1 / 3
Extended Ground Anchor Screws for Mammotion Luba and Yuka Charging Stations and Garages — image 1
1 / 3

Extended Ground Anchor Screws for Mammotion Luba and Yuka Charging Stations and Garages

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Longer screws when you need to go a bit deeper for your Mammotion lawnmower charging station or garage.

Rating
0 / 5
Likes
9
Downloads
95
Makes
0
Views
407
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I wanted to mount my charging station on a pebbled area, where the soil is about 100mm / 4" below the surface. The stock screws weren't long enough, so made these.

Use ASA or other outdoor capable plastic. PETG is likely fine too. Print solid for strength - 6+ walls will do it. 

Print has temporary structural joints built in to stop screws wobbling or toppling during print. These snap off fairly easily. They'll leave some burrs, but it's going in the ground anyway.

Uses the same hex wrench size as the original. Note though that these will not be as strong as the originals - I suggest printing all 8 to give room for a few failures. For harder ground, back it off a quarter turn anticlockwise for every half turn clockwise to prevent soil compacting further and snapping the screw.

Tags