Ratrig V-Minion 1.1 Heatset Parts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
V-Minion 1.1 parts altered to use Voron-standard heatsets.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 107
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Modified model parts using Voron-standard heatsets (M3 5mm diameter). Other heatsets will not work because all these parts have limited depth so the shallow heatset is required.
No real advantage to this, just good for those who don't really like using the hex nuts or screwing directly into plastic.
Y Tensioner
On the outer side, presumably for ADXL, instead of M3x10 or M3x25 into plastic, two M3 heatsets instead. Two versions included Voron-standard or 4mm diameter heatset, the latter is recommended because of the limited space. These holes we offset lower to allow more space for the plastic to deform. M3x10mm is probably best to fit with and without PCB mounted.
Thought about replacing the primary M5 nut which holds tension, but I think the big nut is more secure.
X and Y endstop brackets
Modified backsides for heatsets - strong because the screw is trying to pull the heatset through the plastic. Minimal clearance though, if you push the heatsets too far it'll bust out the other side.
The Y-endstop, the M5 hole on top seemed way too small for the bolt head. Maybe I was using the wrong bolt, anyways, I made it bigger.
Bed Wire Guide
Bottomside heatsets added - the bracket is 2mm thicker at the connection point - you might need longer bolts, but it'll be stiffer.