1 / 4
Ratrig V-Minion 1.1 Heatset Parts — zdjęcie 1
1 / 4

Ratrig V-Minion 1.1 Heatset Parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

V-Minion 1.1 parts altered to use Voron-standard heatsets.

Ocena
0 / 5
Polubienia
3
Pobrania
15
Wydruki
0
Wyświetlenia
107
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Modified model parts using Voron-standard heatsets (M3 5mm diameter).  Other heatsets will not work because all these parts have limited depth so the shallow heatset is required.

No real advantage to this, just good for those who don't really like using the hex nuts or screwing directly into plastic.

Y Tensioner

On the outer side, presumably for ADXL, instead of M3x10 or M3x25 into plastic, two M3 heatsets instead. Two versions included Voron-standard or 4mm diameter heatset, the latter is recommended because of the limited space. These holes we offset lower to allow more space for the plastic to deform. M3x10mm is probably best to fit with and without PCB mounted.

Thought about replacing the primary M5 nut which holds tension, but I think the big nut is more secure.

X and Y endstop brackets

Modified backsides for heatsets - strong because the screw is trying to pull the heatset through the plastic.  Minimal clearance though, if you push the heatsets too far it'll bust out the other side.

The Y-endstop, the M5 hole on top seemed way too small for the bolt head. Maybe I was using the wrong bolt, anyways, I made it bigger.

Bed Wire Guide

Bottomside heatsets added - the bracket is 2mm thicker at the connection point - you might need longer bolts, but it'll be stiffer.

Tagi