1 / 2
Hydroponic Tower Support Circle
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made this for my hydroponic tower, I got from Amazon. My beans needed a bit of a boost!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 14
- Makes
- 0
- Views
- 161
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a print-in-place model with no supports. You'll need to print these 2 parts four times. Then flip two of the parts to create the circle. The circumference of the tower was approximately 14.25 inches, resulting in a diameter of about 4.54 inches. The support sticks out about 9.3 inches.