1 / 3
Bicycle airpump adapter for inflatable objects
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for a connection between the Schrader side of a bicycle air pump and inflatable objects like air mattresses.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 56
- Makes
- 1
- Views
- 205
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When setting up the inflatable pool for our daughter, we ran into the issue that not every part was safe to inflate with a compressor. Unfortunately, I only had a bicycle air pump available, so…
… I designed and printed an adapter! :-)
How to use:
- The adapters should fit into the schrader side of any old bicycle air pump. Open the latch, insert straight, non-tapered side into the pump head and close the latch again. It should be a snug fit, but the adapter will have some room to wiggle around, which is fine.
- The 5 mm version is tapered and inserts into typical smaller inflatables like air mattresses, neck pillows or inflatable water balls.
- The 8 mm is only very slightly tapered and fits larger openings as you might find on inflatable pools.
Recommended material and print settings
- PLA works fine. If the part spends a lot of time exposed to direct sunlight, ASA might be a smart alternative.
- Print it in an upright position, with the pump insert facing the build plate
- No supports, 5 mm brim
- 100% Infill
I would love some feedback if you printed this model - so please upload a picture of your makes!
Happy printing!