RC Car Drift 65mm wheels and tires
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drift wheel and tire combined, 65mm diameter, 12mm hex. The shaft hole is 4mm, but its easy to add a negative cylinder,
- Rating
- 4.667 / 5
- Likes
- 21
- Downloads
- 279
- Makes
- 2
- Views
- 804
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
Drift wheel and tire combined, 65mm diameter, 12mm hex. The shaft hole is 4mm, but its easy to add a negative cylinder, center the wheel and a cylinder of the desired diameter. keep in mind to do ad 0.1mm for tolerances.
I created it for my HyperGO 14211, on the stock wheels dimensions, but its nothing specific to it.
Materials:
PLA is slips very well, is more for carpet drifting, or small places, on hard surface is quite noisy because is so rigid
TPU (95A) has a bit of traction, you can do some higher speed drifting, in my opinion is way more fun.
Printing tips:
0% infill, Concentric top layer, 5 perimeters, enable supports - snug. Any infill you would use is not perfectly distributed in the tire so it will create wheel unbalance. Printing in TPU, 0% infill makes the tire have a little flexibility also. There is a picture with the settings. Or use my profile.
Enjoy as much as i do :)
