RC Car Drift 65mm wheels and tires
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drift wheel and tire combined, 65mm diameter, 12mm hex. The shaft hole is 4mm, but its easy to add a negative cylinder,
- Ocena
- 4,667 / 5
- Polubienia
- 21
- Pobrania
- 281
- Wydruki
- 2
- Wyświetlenia
- 815
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
Drift wheel and tire combined, 65mm diameter, 12mm hex. The shaft hole is 4mm, but its easy to add a negative cylinder, center the wheel and a cylinder of the desired diameter. keep in mind to do ad 0.1mm for tolerances.
I created it for my HyperGO 14211, on the stock wheels dimensions, but its nothing specific to it.
Materials:
PLA is slips very well, is more for carpet drifting, or small places, on hard surface is quite noisy because is so rigid
TPU (95A) has a bit of traction, you can do some higher speed drifting, in my opinion is way more fun.
Printing tips:
0% infill, Concentric top layer, 5 perimeters, enable supports - snug. Any infill you would use is not perfectly distributed in the tire so it will create wheel unbalance. Printing in TPU, 0% infill makes the tire have a little flexibility also. There is a picture with the settings. Or use my profile.
Enjoy as much as i do :)