Deck plate cover for 3.25" cowl vent with SAE power plug
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement deck plate cover for boat cowl vent, with holes to attach SAE plug for solar panel
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 91
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a very specific design that might not be useful to many, but I'm sharing it just-in-case.
The snap-in deck plate cover for the cowl vent on my sailboat was lost on the road some time ago, and after adding a solar panel to my bow pulpit I've been running the power cable through the gaping hole in the deck. So while designing a replacement cover, I decided to integrate a flush-mount SAE power plug to pass-through power from the exterior solar panel to the interior electrical system.
The diameter of the main part that slides into the vent hole is 3.25" and it goes about 1" deep. The hole for the plug is 0.859" and the holes for bolts allow for #8 bolts with nylock nuts on the underside. I plan to paint on some PlastiDip on the mating surface as a gasket to weatherproof it.
Printed in PETG on a prusa mini+ with three perimeters; 15% gyroid for most of the infill, except for a section of 100% rectilinear where all the holes are so I could tighten down the power plug without crushing the item. The infill modifier block is included in the 3MF project but isn't part of the STL model.
This is the specific SAE power plug I used:
https://www.amazon.com/dp/B0CZ9JQ7T9