Bed adhesion and warp test. Parametric with OpenSCAD.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple parametric bed adhesion and warp test using OpenSCAD
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 101
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial
A simple adhesion and warping test that is parametric in OpenSCAD.
Place “mainpart.stl” and “adhesion-warp-test.scad” in the same folder.
Set the base_length (the length of the block that is printed on the bed) and the level (the highest ‘stair’ level). Note: the height of the model will be 9mm x (level).
Optimized for 0.4 nozzles and 3 perimeters (this minimizes the retraction).
Printing at 100% infill is recommended.
A large temp gradient, too much cooling, or uneven cooling should cause the model to warp. Test by laying it down on a flat surface.
Model is inspired by: https://www.printables.com/model/1325998-bed-adhesion-test-bed-adhesive-tester-how-far-can