1 / 5
ToneTwister 3D Printable Volume Knob for Potentiometers. — image 1
1 / 5

ToneTwister 3D Printable Volume Knob for Potentiometers.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Nederlands/English Onder/Below!Bekijk ook mijn YouTube-kanaal en steun mij door je te abonneren en misschien wel te…

Rating
0 / 5
Likes
1
Downloads
13
Makes
0
Views
68
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Nederlands/English Onder/Below!

Bekijk ook mijn YouTube-kanaal en steun mij door je te abonneren en misschien wel te kijken!

Also check out my youtube channel and support me by subscribing and possibly watching!

www.youtube.com/@ElektroTechNL http://www.youtube.com/@ElektroTechNL?sub_confirmation=1

Nederlands.

ToneTwister 3D-printbare volumeknop voor potentiometers

De ToneTwister is een strak passende volumeknop, speciaal ontworpen voor standaard potentiometers van 15 mm (zie foto's ter referentie). Dankzij het nauwkeurige ontwerp sluit hij mooi aan en draait hij soepel zonder speling.

Voor extra stevigheid kun je een heel klein beetje secondelijm aan de onderkant van de knop aanbrengen voordat je hem op de potentiometer drukt. Zo blijft de knop goed vastzitten en voorkom je dat hij tegen de printplaat (PCB) schuurt tijdens het gebruik.

Aanbevolen printinstellingen:

Infill (vulling): 15% of naar eigen voorkeur

Laaghoogte: 0.20 mm (standaard profiel)

Support: Niet nodig

Nozzle: 0.4 mm

Hechting: Mocht de print loskomen van het printbed, overweeg dan om een brim toe te voegen bij mij bleven ze echter perfect zitten zonder extra maatregelen.

De ToneTwister combineert functionaliteit met een strakke afwerking en is perfect voor je DIY-audio of elektronica projecten!

English.

ToneTwister 3D Printable Volume Knob for Potentiometers

The ToneTwister is a snug-fitting volume knob, specifically designed to fit standard potentiometers 15 mm (see photos for reference). Its precise fit ensures smooth turning without wobble or play.

For extra stability, you can apply a very small amount of superglue to the bottom of the knob before pressing it onto the potentiometer. This helps keep the knob firmly in place and prevents it from rubbing against the PCB during use.

Recommended print settings:

Infill: 15% or as preferred

Layer height: 0.20 mm (standard profile)

Support: Not needed

Nozzle: 0.4 mm

Adhesion: If you experience detachment from the bed, consider using a brim though in my case, the print adhered perfectly without it.

The ToneTwister combines functionality and a clean finish ideal for your DIY audio or electronics projects!

Category: Electronics

Tags