DJI RC-N multitool/micro SD ejector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
My fingers can't properly pry out the USB cable on the DJI RC-N1. Instead I would have to use my nails which causes the plastic on the cable to get scratched and damaged. So I designed this pry tool which allows you to quickly and easily remove the USB cable from the remote.
The opposite end of the tool also counts as an micro SD card ejector. The original tool has this end the same width as a micro SD card. However in the V2 I increased the structural stability of the ejector and the full width was no longer seen as necessary
On the left is the V1 and on the right is the V2
You can print with PLA
both versions should be printed on their sides however you should print the V1 with supports