Medal holder - artistic dance design
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix for the medal holder to hang on your wall. Can be mounted without glue or screws!
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 90
- Makes
- 0
- Views
- 364
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a medal holder that you can hang on your wall. Is made out of 5 parts, that can be mounted without glue or screws, just interference (there is a lot of interference, but if you push enough, you will be able to assemble it). If you have difficult sliding it in the lower part, use a little bit of oil lube and a rubber hammer.
You must print it using SUPPORTS, between the parts where the 5 pieces are going to join. Be careful, remove all the excess otherwise you are going to have problems while mouting it.
To hang on the wall you need this type of hooks: https://lc.cx/IwnjzK
Credit to https://www.klipartz.com/it/sticker-png-bzwko for the figures used in this design
If you have problems, contact me! If you like it, leave a like and a comment, thanks :)