1 / 7
Customizable LED Channel Hanger for RepRack / 1/2" EMT
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hang aluminum LED channel and lighting from your RepRack setup!
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 13
- Makes
- 0
- Views
- 150
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Hang aluminum LED channel and lighting from your RepRack setup!
This print allows you to friction fit aluminum LED channels into a slot hanging below the ½" EMT conduit structure. This works great for indirect lighting below a RepRack shelf, but could also be used for any other ½" EMT project.
Files:
- The height of the led_clip file brackets is set to allow clearance between the LED channel and the lowest part of the printable RepRack brackets. If you need more or less space allowance, this is customizable as well.
- The height of the led_clip_slim brackets is much closer, and will not clear the lower tab on the printable RepRack brackets. Only use this if you test and it works for you, or you are using ½" EMT for something else!
Hardware:
- The included STL files uses these LED channels for wide LED strips: https://www.amazon.com/dp/B07FDV1RH9
- The screw hole to lock the bracket fits the same #6 x 5/8" (16mm) Thread Forming Screws for Plastic used in the stock RepRack setup. I have not found these to be necessary, but YMMV.
Customization:
- LED Channel: If you use different aluminum profile, all you need is the cross-section measurements. Enter those in the OpenSCAD customizer and print a test piece.
- The height of the brackets is set to allow clearance between the LED channel and the lowest part of the printable RepRack brackets. If you need more or less space allowance, this is customizable as well.
- Everything else is parameterized as well!
If you don't have a RepRack, you can build one here: https://www.printables.com/model/129024-reprack-open-source-spool-holder-and-storage-syste