Handhold VHF Moxon based on DL2MAN
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified DL2MAN's Moxon Design for a handhold VHF variant. Handle based on OM0WT but modified for better printability
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 104
- Makes
- 0
- Views
- 742
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
The Feedpoint Part is modified to be not so pointy (because pointy is scary ;-). Also I reduced the drill size of the inner holes, so you can use a cable tie (or knot) for strain relief.
The optional cap can be used to close/protect the Feedpoint connection.
Length of the middle tube is 240mm. All other length for wire and tubes are according DL2MANs definition. Thanks to Manuel for the initial Design!
BOM:
4x 337,5mm of a 10mm diameter plastic tube
1x 240mm of a 10mm diameter plastic tube
2x 470mm Wire (22AWG or similar)
1x 1024mm Wire (22AWG or similar)
1x BNC Jack
2x cable ties