🍴 Cutlery drainer/dryer/box - hanging possibility

Intro:

• i got inspiration at print from Maciey, but i needed different properties.
  • so i have created my own model (Blender file attached)

Characteristics:

• inner area:
  • all edges rounded, including inner bottom corners!
    • → ✅ easy cleaning
  •  bottom is 5º angled
    • → ✅ water runs out nicely 
  • as simple as possible
    • no holes in the outer walls
      • again, that would only be dirty after some time → more work to clean
    • one hole in the bottom
      • ✅ so the water pours out only at one point 
• versions:
  1. hanging - I needed this for myself - it saves space around the sink (but those hooks might not fit everybody needs…)
  2. just standing, without hanging hooks

Print instructions:

• the box is rather small (as I did not want it  to take too much space above sink for my usage, but at this size, it is perfect for me)
  • 💡 so maybe think about scaling it up somehow
• PLA/PETG
• see 3mf

Usage:

• possibly put inside on the bottom rubber grid, so cutlery is not slipping (if you dont like that)
• hanging version:
  • I have designed supports for the upper hooks as part of the model - which should be cut off / ripped off after printing (can be seen in 3mf)
    • this saves a lot of supports, otherwise supports would be needed from the plate up to the hooks
    • the cutted part is on the back of the print thus not visible when using