UGREEN 40Gbps M.2 NVMe Enclosure and 40mm Fan Holder - 3D Parametric Model (stackable)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D Parametric Model (OpenSCAD) of holder for UGREEN 40Gbps M.2 NVMe Enclosure and standard 40mm PC fan (stackable)
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 27
- Makes
- 0
- Views
- 323
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- BSD License
Intro
3D Parametric Model (OpenSCAD) of holder for UGREEN 40Gbps M.2 NVMe Enclosure and standard 40mm PC fan (stackable)
Detailed model design description, as well as source code are hosted on GitHub
Demo photos uploaded here are in two groups:
- single holder with old disk plates (no airflow around disk enclosure)
- two stacked holders with new disk plate (current design - nearly hollow disk plates)
Objectives
Main objective is keeping drive in natural position (largest plane parallel to surface) with proper airflow and adding backup/support 40mm fan next to exhaust of built-in one. The holder is designed to be either placed on top of desk/bench/shelf or attached underneath desk/bench/shelf. Additionally, it's designed to be stackable vertically (screwable) and placed horizontally (no interferences on surfaces).
3D model is designed in such a way that print should use as little material as possible, which will not limit access to ambient air. Another goal is to have print as simple and quick as possible, for example by eliminating supports.
Printing and assembly
Minimal extra parts needed (excerpt from BOM for single holder):
- 16x M3x8 (or M3x10) flat-head screw
- 16x M3 nut
- 4x M4x40 non-flat-head screw
- 4x M4 nut
- 1x 40x40x20mm standard PC fan
Printing and assembly are extensively described in documentation. Please also check important notes about material used.
Printing and assembly instructions - short version:
- use appropriate filament - only use PLA for disk plates if you are 100% sure that exterior of disk enclosure won't ever reach glass transition temperature (55-60°C)
- print each attached STL part twice - use auto-orientation, no supports are needed, choose your favourite infill
- screw fan (green in picture below) and disk (blue in picture below) plates to top and then bottom plates (yellow in picture below) by inserting nuts to rectangular holes in edges of fan and disk plates
- insert and screw fan so it blows outwards
- insert disk enclosure, keeping Thunderbolt connector outside
