Phillips Hue Lamp Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A minimalistic 3D-printed holder to mount a Hue Lightguide E27 bulb onto a standard E27 socket
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This designer-style holder is made to hang a Hue Lightguide E27 bulb. It screws directly onto a standard E27 lamp socket, and the top cover includes a recessed thread to fit an M10x1 strain relief, allowing for clean and safe cable routing.
💡 The model was printed in ASA for better heat resistance, then sanded, primed with filler, sanded again, and spray-painted in matte black for a sleek, premium look.
🔧 Note: The top cap of the socket was not used in this setup. The printed part replaces it entirely.
Printing Recommendations:
Material: ASA (for heat resistance)
Supports: Recommended for the recess at the top
Infill : Printed with 20-30% Cubic
Brim: Recommended
Bed Adhesion: I recommend a bed adhesive like 3DLac
Build Plate: Smooth or matte surface recommended for easier sanding of the first layer
Printer: Enclosed 3D printer strongly recommended for ASA ( or skirt if its an open style printer) as well as proper ventilation because its toxic
Wall/Perimeters: Use 4 or more perimeters for proper sanding and durability
Top/Bottom Layers: Minimum 4 top and 4 bottom layers for a clean surface finish
Hardware Used
Strain Relief M10x1
https://amzn.eu/d/edcOy8O
E27 Socket with Threaded Strain Relief
https://amzn.eu/d/fK9xFi3
Feel free to remix or improve the design — feedback and ideas are always welcome!